...
For this step you will need to depin and repin your existing stock DME connector for the fuel injectors. Remove the fuel injector connector from the DME connector housing. Familiarize yourself with the pin positions on the connector shown in green. Remove all wires from the connector by depressing the tab shown in red while lightly pulling the wire out of the connector. Make sure you keep the tab depressed while pulling on the wire. The wires should separate from the connector body with minimal effort.
This marks the end of the depinning process and the beginning of the pinning process.
Next familiarize yourself with the terminals on the end of our fuel injection harness. You will find a heatshrink label on each wire with numbers from 7 to 12.
...