Versions Compared

Old Version 1

changes.mady.by.user Austin Vann

Saved on

compared with

New Version Current

changes.mady.by.user Austin Vann

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#F4F5F7

Feed our ignition coil harness into the DME box through the same rubber sheathing as the factory harness.

  • Lay the ignition coil harness over the valve cover and bunch the loose wire ends together.

  • Gently wrap tape around the loose wire ends to protect the terminals from damage.

  • Gently push the harness through the rubber sheathing until the taped end appear inside the DME box. Pull through about 1 foot of the harness.

Info

Familiarize yourself with the terminals on the end of our ignition coil harness. You will find a heatshrink label on each wire with numbers from 1 to 6 circled in red below.

...

Info

Note the position labels on the connector below circled in green

...

Warning

The wires must be installed into the correct position or vehicle/engine damage can occur!

...

At this point the ignition coil connector can be reinserted into the DME connector housing.

Tip

Route the harness into the center of the valve cover from the rear of the engine. Attach ground ring terminals to their original locations and plug the ignition coils in. This concludes the ignition coil harness installation instructions.