Tools you will need
Basic tools such as sockets, wrenches, hammer and etc.
Towels for fuel spills
Depinning tools
Heat gun
Nylon pipe brush
Basic Disassembly
Disconnect battery
Remove cowl
Remove engine cover
Open DME box
Remove factory fuel injectors
Remove fuel rail and high pressure fuel pump
Open fuel injector & ignition coil harness plastic housing (mounted to the valve cover) if you still have it.
Now you are ready to depin and remove the factory fuel injector harness. Follow the depinning steps outlined below and pull the factory harness out of the DME box towards the engine.
Only perform the depinning process at this time. The end of the depinning process is designated by a purple message like this one.
If you are replacing the factory ignition coil harness with one of ours, follow the depinning steps outlined below and pull the factory harness out of the DME box towards the engine.
Only perform the depinning process at this time. The end of the depinning process is designated by a purple message like this one.
The generalized disassembly process is now complete. Proceed with installation.