Atlassian uses cookies to improve your browsing experience, perform analytics and research, and conduct advertising. Accept all cookies to indicate that you agree to our use of cookies on your device. Atlassian cookies and tracking notice, (opens new window)
Confluence
Public - Nexsys Motorsport
Results will update as you type.
  • Home
  • N54 Port Injection Conversion
    • Basic Information
    • Frequently Asked Questions
    • Value Proposition vs Standalone ECU
    • Pricing
    • Installation Instructions
      • Preparation & Disassembly
      • Installation
        • Direct Injector Plug Installation
        • Fuel Injector Harness Installation
        • Ignition Coil Harness Installation
        • Installing Y-Splitter
        • HPFP Block Off Installation
    • Tuning Guide
  • Port Injection Calculator Change Log
  • N54 Port Injection Updates
  • N54 Integrated Oil Pressure Sensor Kit
    Calendars
You‘re viewing this with anonymous access, so some content might be blocked.
/
HPFP Block Off Installation
Published Jun 21, 2024

    HPFP Block Off Installation

    Our High Pressure Fuel Pump block off plate is very easy to install. The plate comes with an O-ring and 3 bolts as seen below.

    Place the O-ring over the protruding center section of the plate.

    HPFP Plate - 1.png

    Install the plate where the HPFP used to be installed and tighten the plate to factory torque specification (9 nm). This concludes the installation instructions for the HPFP block off plate.

     

    HPFP Plate -2.png

     

    {"serverDuration": 13, "requestCorrelationId": "008db582323c4ef7b3de2e0aa53eea96"}