Installing Y-Splitter

Our kit includes a small orange Y-Splitter (shown below). This splitter provides positive battery voltage to the port injector harness and the ignition coils.

First locate connector X60053 (Green) inside the DME box (shown below in green)

Using a pick, depress the tab to the left on the back of the connector that attaches it to the DME box and pull up to slide the connector off it’s mount. Depress the two tabs on the side and separate the male and female portions of the connector.

Next locate the wire in pin position 8 of the male connector (labels are inside the connector), its terminals have tabs (male) instead of sockets (female). We will be removing this wire from the connector. Begin by inserting a depinning tool into the locking tab seen below circled in red. Twist the depinning tool and the tab should release rotate away from the connector body.